IKEA HYGIENISK Bedienungsanleitung Seite 13

ENGLISH
Number Setting
7 Display on floor
1) For more details, refer to the information provided in this chapter.
You can change the basic settings in setting
mode. Instructions on how to configure the
appliance are provided further in this
chapter.
When the appliance is in setting mode, the
display shows a digit and a letter. For each
setting, a dedicated letter is displayed. The
dedicated letters are indicated in the table.
The order of the basic settings presented in
the table is also the order of the settings in
setting mode.
The water softener
The water softener removes minerals from
the water supply, which would have a
Water hardness
German degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting.
2) Do not use salt at this level.
Regardless of the type of detergent used,
set the proper water hardness level to
keep the salt refill indicator active.
Values
1C (on)
0C (off)
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
Activate or deactivate the TimeBeam.
Factory setting: 1C.
negative effect on the washing results and
on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water in
your area. It is important to set the right
level of the water softener to assure good
washing results.
mmol/l Clarke de‐
grees
8.4 - 9.0 58 - 63
7.6 - 8.3 53 - 57
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
4.0 - 5.0 28 - 35
3.3 - 3.9 23 - 27
2.6 - 3.2 18 - 22
1.9 - 2.5 13 - 17
0.7 - 1.8 5 - 12
<0.7
1)
Description
Water softener level
< 5
13
10
9
8
7
6
1)
5
4
3
2
2)
1