Control And Display Elements - HEYLO DT 760 Betriebsanleitung

Dehumidifier DT 760
1 Housing
The device features the following safety devices:
Signalling devices
The indicators on the control panel indicate the
operating status of the device (for details, see

Control and display elements

Safety devices
Safety devices protect hazardous areas on the
device. They have no influence on the device's
movements.
Safety guards
Safety guards prevent or access to the rotating or
moving parts of the device. They may only be re-
moved for set-up, maintenance or repair work and
must be mounted again before restarting.
The device features the following safety devices:
– Housing
– Protective grille in front of the air outlet.
Other safety devices
– The power cable of the device is equipped
with an earthing-pin ("Schuko") plug.
14.4 Control and display elements
The device is operated through the control devices
on the operating panel at the front.
1 2 3
10 9
Fig. 14: Operating panel
1 ON/OFF indicator
3 Display
36 / 52
2 Grille covering air
inlet opening
[ 36]).
4 5
8 7 6
2 ALARM indicator
4 WORK indicator
5 FULL indicator
7 HOURS button
9 SET- button
– ON/OFF button – start button: Press the
ON/OFF button to switch the device on and
off. When the device is switched on, the
ON/OFF indicator is lit in green and the device
is automatically set to continuous mode.
– SET +/SET – buttons – adjusting target air
humidity: Press the SET + button to increase
the target air humidity. Press the SET – button
to reduce the target air humidity.
When one of these buttons are pressed, the
display changes from read-only to setup mode.
Press one of the buttons again to call up the
currently set target humidity.
NOTICE! The integrated hygrostat is only
used to determine the general operating pa-
rameters. It does not make accurate meas-
urements of the air humidity in the room. For
accurate measurements, use an external,
properly calibrated measuring device. HEYLO
shall not be liable for damage caused by ex-
cessive drying of materials.
– HOURS button – operating hours counter:
Press and hold the HOURS button for a few
seconds to view the operating hours of the
compressor on the display.
To reset the operating hours counter: Press
and hold the HOURS button for 4 seconds.
– HOURS button – total operating hours coun-
ter: Simultaneously press and hold the HOURS
and the SET+ buttons for few seconds to view
the total operating hours of the device on the
display.
– PUMP button – start optional condensate
pump: To start the pump function, simultane-
ously press and hold the PUMP and SET +
buttons until the FULL indicator lights up
briefly. Subsequently, message "PUNP" is dis-
played. The pump is now ready for operation,
6 PUMP button
8 SET+ button
10 ON/OFF button
EN