Control And Display Elements - HEYLO DT 860 Betriebsanleitung

2
Fig. 15:
Safety devices
1 Grille covering air
inlet opening
The device features the following safety devices:
Signalling devices
The indicators on the control panel indicate the
operating status of the device (for details, see

Control and display elements

Safety devices
Safety devices protect hazardous areas on the
device. They have no influence on the device's
movements.
Safety guards
Safety guards prevent or access to the rotating or
moving parts of the device. They may only be re-
moved for set-up, maintenance or repair work and
must be mounted again before restarting.
The device features the following safety devices:
– Housing
– Protective grille in front of the air outlet.
Other safety devices
– The power cable of the device is equipped
with an earthing-pin ("Schuko") plug.
EN
1
2 Housing
[ 37]).
14.4 Control and display elements
The device is operated through the control devices
on the operating panel at the front.
1 2 3
10 9
Fig. 16:
Operating panel
1 ON/OFF indicator
3 Display
5 FULL indicator
7 HOURS button
9 SET- button
– ON/OFF button – start button: Press the
ON/OFF button to switch the device on and
off. When the device is switched on, the
ON/OFF indicator is lit in green and the device
is automatically set to continuous mode.
– SET +/SET – buttons – adjusting target air
humidity: Press the SET + button to increase
the target air humidity. Press the SET – button
to reduce the target air humidity.
When one of these buttons are pressed, the
display changes from read-only to setup mode.
Press one of the buttons again to call up the
currently set target humidity.
NOTICE! The integrated hygrostat is only
used to determine the general operating pa-
rameters. It does not make accurate meas-
urements of the air humidity in the room. For
accurate measurements, use an external,
properly calibrated measuring device. HEYLO
shall not be liable for damage caused by ex-
cessive drying of materials.
– HOURS button – operating hours counter:
Press and hold the HOURS button for a few
seconds to view the operating hours of the
Dehumidifier DT 860
4 5
8 7 6
2 ALARM indicator
4 WORK indicator
6 PUMP button
8 SET+ button
10 ON/OFF button
37 / 55