Wear Parts; Lubrication - Coboc TEN Merano Bedienungsanleitung

• Only replace the components on your Coboc bike with original parts
or those that have been authorized by Coboc. All warranty claims
shall lapse if not doing so.
Your bike, just like all mechanical components, is exposed to high
usage and wear. Different materials and components may react
differently to wear and abrasion due to usage. Using a compo-
nent longer than the intended period of use may lead to sudden failure
and therefore injure the rider. Any kind of fissure, tear or color change on
those high usage parts indicates that the period of use as expired. The
according component should immediately be replaced.

Wear parts

Especially check on the following wear parts regularly:
• Tires and tubes
• Chain, sprocket and chain ring
• Brake pads
• Brake discs
• Ball bearings
• Saddle and grips
Inspect the right fit of every screw and nut and, if necessary, tighten them
again. Always bear in mind the correct Tightening Torque (s. table Tight-
ening Torque).
Maintainance & Care

Lubrication

To ensure efficient functioning and a long lifetime, certain parts require
regular cleaning and lubrication. Oils, fats and other lubricants should be
meticulously kept away from rims, brakes, brake pads and brake discs.
Carbon components may under no circumstances be assembled
with grease or other lubricants, as this could reduce friction
between them and therefore lead to material damage due to
higher Tightening Torque. Please only use special assembly paste when
assembling carbon components. It increases the friction between the
components and therefore prevents material damage.
What to lubricate
Chain
Shift cable
Aluminum seat post in
aluminum frame
Joints of the rear derailleur
When to lubricate What to use as lubricant
after cleaning, after riding in Chain lube
the rain, after about 300km
with poor function or Silicon-free fat
1x annually
during installation Assembly grease
with poor function or Spray oil
1x annually
59