Operating The Lights; Notes On Using The Brakes; Level Of Motor Support; Two Different Riding Modes - Coboc TEN Merano Bedienungsanleitung

50

Operating the lights

Your TEN Merano is equipped with an integrated lighting system, which
can also be operated by the power button. You can turn it on and off by
pressing down the power button for three seconds. The lighting system is
controllable in both "bike on" and "bike off" mode and turns off automati-
cally after your bike stays unused for more than four minutes.
Due to residual charge the lighting system can be used for up to two hours
after battery discharge.

Notes on using the brakes

Make sure to know which brake lever belongs to which brake before start-
ing your ride. As standard the right brake lever belongs to the rear wheel
brake and the left brake lever belongs to the front wheel brake.
Regularly check the friction components for wear.
It is important for you to also check the wear on your rim brake flanks.
Also make sure to check for brake pad wear on the brake shoes (s. chapter
Maintenance & Care).
Handling
If wear is too heavy on any of these components, this may lead to total
failure of the brake system. Hard falls and serious injury can be the result.
Use your brakes in a controlled and well-timed way. Too heavy
breaking may leave your wheels blocked and therefore lead to
loss of control. Hard falls and serious injury can be the result.
Hydraulic disc brakes
Avoid using the brakes permanently if riding downhill for longer periods
as this might cause steam bubble formation and therefore lead to loss of
control. Hard falls and serious injury can be the result. Always try to fully
release the brakes or to switch between front and rear wheel brakes. That
way the brake system can cool off. If necessary take a short break to cool
it off. Always check the braking point before your journey. If you are able
to pull the lever all the way back to the handlebar or of the braking point
changes while riding you may not continue riding. Let your Coboc dealer
either bleed your brake or fix it, if needed.

Level of motor support

The level of motor support adapts to your riding behavior. The stronger
you tread the pedals, the more torque value is in the motor. This makes a
"level of support" choice unnecessary. However, you can apply a fine-tun-
ing of your Coboc Electric Drive on your phone via our Coboc App. Please
note, that you may not use the Coboc App while riding your bike (s.
chapter Coboc App).

Two different riding modes

Since firmware version 3.34 you are able to choose between two different
riding modes. You can either access them via our Coboc App or by simply
operating the power button on your bike.
Drive settings for both modes can be adjusted individually and remain
even if smartphone and bike are not connected.