Coboc TEN Merano Bedienungsanleitung Seite 58

58
• Make sure that your brakes are working properly before every ride.
Both brakes should work flawlessly and delay sufficiently. You should
not be able to pull the brake levers all the way to the handlebar.
Check the wear of the brake pads and the brake disc approximately
every month (s. Adjusting the brakes).
• Check the condition of your brake lines regularly. Under no circum-
stances should brake lines be broken or brake fluid leak out.
• Make sure to check pressure on both tires before every journey.
Recommended tire pressure is dependent of the type of tire you
are using and is usually indicated on the side of the tire. Your TEN
Merano is equipped with WTB Byway 650b (47-584). The air pressure
specified by the manufacturer is between min. 35 psi and max. 50
psi. If you want to utilize other tires, please make sure that rims and
tires are compatible and that the maximum permitted air pressure for
rims and tires are not exceeded.
• Make sure that the valve is looking straight out of the rim. It should
be more or less aligned with the spokes. It could rip off, if not posi-
tioned correctly.
• Grease the chain with appropriate chain lube (s. Lubrication) and
check the chain tension at least once a month (s. Adjusting the chain
tension). Check for wear with the help of a chain gauge or ask your
Coboc dealer to judge the wear of your chain.
• Check for lateral bearing clearance on the wheel hubs roughly
once a year. Please replace the wheel bearing if the rim is moving
although the tire is screwed tightly to the frame. The same applies,
if wheels are not running smoothly without brakes sliding. Please
contact your Coboc dealer in this case.
• Check for bearing clearance on the pedals once a month by trying to
move them across the pedal axles. You should replace the bearings,
if you can move the pedals from side to side. Please contact your
Coboc dealer in this case.
Maintainance & Care
• Roughly once a month should the crank lever screwing on the spin-
dle be checked. Use a torque wrench to screw the crank lever with
the according Tightening Torque (s. table Tightening Torque).
• Check the spoke tension on your tires roughly once a month. To do
this, simply press two adjacent spokes together with one hand. This
helps you find out if one of your spokes is more loose than others.
Should this be the case, make sure to visit your Coboc dealer in
order to center the according wheel.
• Also make sure to check the concentricity on your wheels once a
month. Make sure to have them centered by your Coboc dealer if
they are not running smoothly anymore.
• Check the handlebar screwing on your stem once a month. Also,
check the stem screwing on the steer tube. Use a torque wrench for
this (s. table Tightening Torque).
• Take time to inspect your handlebar for damage like dents, defor-
mation, scratches or holes. In case of doubt or after three years we
advise you to have your handlebar replaced by your Coboc dealer.
• Check the clearance on your headset once a month (s. Adjusting the
headset).
• Check for proper screwing of your wheels regularly. Use a torque
wrench to make sure the screws are still tight at least once a month
(s. table Tightening Torque).
• Check the motor cable (running along the right chain stay) for any
exposed contacts or other damage. A damaged motor cable might
lead to electric shocks and cause serious injuries. In case of defect,
please contact your Coboc dealer.
• You may only use the already built-in front and rear light developed
by Coboc. If they show signs of damage or are not working properly,
please contact your Coboc dealer.