Selection Of The Pumps - Dibo 2D MPU-M Bedienungsanleitung

4.6.3. Selection of the pumps

This indication comes on the screen when the water tank is filled and if there's no pump working.
One should press on the + key to switch on the pumps.
If one then presses the + key, this screen will arise a few seconds later and all pumps are set active.
This will tell that all pumps are integrated in the cycle.
If one presses the MIN key, one could set the pump on non- active.
After a few seconds comes on the screen which pump stays active.
If one presses again on the MIN key, one set the other pump on active and she who was active on
non- active. So with the MIN key one could keep switching always between the pumps.
To activate both pumps again, one should press on the + key.
DiBO b.v. 55