Troubleshooting; Possible Cause - Scheppach HM100TC Original Bedienungsanleitung

You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.

17. Troubleshooting

The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails to
work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Fault
The compressor does not
start.
The compressor starts but
there is no pressure.
The compressor starts,
pressure is shown on the
pressure gauge, but the
tools do not start.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

Possible cause

No supply voltage.
Insufficient supply voltage.
Outside temperature is too low.
Motor is overheated.
The safety valve leaks.
The seals are damaged.
The drain plug for condensation
water leaks.
The hose connections have a
leak.
A quick-lock coupling has a leak.
Insufficient pressure set on the
pressure regulator.
Remedy
Check the supply voltage, the power plug and the
socket-outlet.
Make sure that the extension cable is not too long. Use
an extension cable with large enough wires.
Never operate with an outside temperature of below
+5° C.
Allow the motor to cool down. If necessary, remedy the
cause of the overheating.
Have a service center replace the safety valve.
Check the seals and have any damaged seals replaced
by a service center.
Tighten the screw by hand. Check the seal on the
screw and replace if necessary.
Check the compressed air hose and tools and replace
if necessary.
Check the quick-lock coupling and replace if neces-
sary.
Increase the set pressure with the pressure regulator.
GB | 27