Controls - Toro TimeCutter ZS 4200T Bedienungsanleitung

Controls

Become familiar with all the controls before you start
the engine and operate the machine.
Control Panel
1. Throttle control
2. Choke control
Key Switch
The key switch, used to start and shut off the engine,
has 3 positions: O , R
FF
Refer to Starting the Engine (page
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
position (Figure 6).
Choke Control
Use the choke control to start a cold engine
Blade-Control Switch (Power
Takeoff)
The blade-control switch, represented by a
power-takeoff (PTO) symbol, engages and
disengages power to the mower blades
Figure 6
3. Blade-control switch
(power takeoff)
4. Key switch
, and S (Figure
UN TART
20).
to F
LOW
(Figure
(Figure
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction
Park Position
Move the motion-control levers outward from the
center to the P
(Figure 23). Always position the motion-control levers
into the P
ARK
leave it unattended.
Smart Speed™ Control System
Lever
The Smart Speed™ Control-System lever, located
below the operating position, gives you a choice to
drive the machine at 3 speed ranges— trim, tow, and
g293303 mow (Figure
Fuel-Presence Window
You can use the fuel window, located on the left side
of the machine, to verify the presence of fuel in the
tank (Figure
6).
AST
6).
1. Fuel-presence window
6).
10
position when exiting the machine
ARK
position when you stop the machine or
26).
7).
Figure 7
(Figure 5).
g292100