Inserting/Changing The Remote Control Battery; Fitting The Feet; Handling And Operation; Switching The Appliance On And Off - Silvercrest SKD 2300 D5 Bedienungsanleitung

Inserting/changing the remote control battery

If the battery in the remote control
inserted.
♦ Open the battery compartment
(see description on the rear of the remote control
♦ Remove the old battery from the remote control
NOTE
Please follow the disposal instructions (see section Disposing of the batteries).
►
♦ Insert a new CR2032 battery into the battery compartment
Ensure the +/- terminals are correctly aligned.
♦ Slide the battery compartment

Fitting the feet

♦ Place the appliance upside down on a soft surface, e.g. a carpet.
♦ Fit the feet

Handling and operation

NOTE
► All functions can be used with the buttons on the device as well as with the
remote control
This section provides you with important information on handling and using the appliance.
Switching the appliance on and off
The main switch
♦ Insert the power plug into a mains wall socket.
♦ Switch on the appliance using the main switch
switch last if you are no longer using the appliance.
♦ When switched on, the integrated control lamp in the main switch
You will hear a beep and the temperature will be shown on the display
♦ Now press the On/Off button
operation and the display
the target temperature
SKD 2300 D5
25
30
30
6
to the bottom of the appliance using 2 screws
25
.
8
disconnects the appliance fully from the mains power supply.
2
shows the preset heating level (2300 W)
19
.
is dead, a new CR2032 battery needs to be
on the underside of the remote control
25
).
25
.
back into the remote control
8
first; or switch off at the main
21
33
or . The appliance is now ready for
GB │ IE │ NI │ CY
25
30
.
25
.
34
on each foot.
8
lights up.
2
.
10
and
│
11 ■