Setting Up; Set-Up Location Requirements; Electrical Connection - Silvercrest SKD 2300 D5 Bedienungsanleitung

Setting up

Set-up location requirements

For safe and trouble-free operation of the appliance, the set-up location must fulfil the
following requirements:
■ The appliance may only be operated in a vertical position and fully assembled.
■ The appliance must be placed on a firm, flat and horizontal surface.
■ The minimum clearances between the housing and other objects must be main-
tained: 10 cm at the sides, 30 cm above and 50 cm in front.
■ Ensure that air can always enter and escape freely. Otherwise, there could be a
heat build-up in the appliance.
■ Do not place the appliance in a hot, wet or extremely moist environment or in the
vicinity of flammable materials.
■ The mains power socket must be easily accessible so that the power cable can
be easily disconnected in an emergency.
DANGER
Fire risk due to contact with materials!
There is a risk of fire if the heating elements come into contact with
flammable materials!
► Do not place the appliance in the vicinity of curtains and other flammable materials.
► Do not allow flammable materials (i.e. textiles) to come into contact with the
appliance.
► Do not cover the appliance.

Electrical connection

To ensure safe and trouble-free operation of the appliance after making the electrical
connection, please observe the following advice:
CAUTION
► Before connecting the appliance, compare the connection data (voltage and
frequency) on the rating plate with that of your mains power supply. These data
must agree so that no damage is sustained by the appliance.
► Ensure that the mains power cable is not damaged and is not running over hot
surfaces and/or sharp edges.
► Ensure that the mains power cable is not taut or knotted.
│ GB │ IE │ NI │ CY
■ 10 SKD 2300 D5