Electrical Connection; Inserting Batteries Into The Remote Control; Operating Components - Silvercrest SWW 1500 A1 Bedienungsanleitung

Electrical connection

GB
IE

Inserting batteries into the remote control

Operating components

Device
Display
AUTO ON button
2
3 POWER/MODE button
+/- buttons
4
AUTO OFF button
5
POWER main switch
6
7 Mains power cord
8 Pedestals
9 Heating element
Carrying handle
10
Remote control
AUTO ON button
11
POWER/MODE button
12
+/- buttons
13
AUTO OFF button
14
Battery compartment
15
8
Initial use/Operating components
For safe and faultless operation of the device with electrical connection observe
the following advice:
CAUTION
► Before connecting the device compare the connection data (voltage and
frequency) on the rating plate with that of your mains power supply. This
data must be in agreement so as to avoid damage to the device.
► Make sure that the mains power cord is not damaged and is not running
over hot surfaces and/or sharp edges.
► Make sure that the mains power cord is not stretched or knoted.
♦ Open the battery compartment on the rear panel of the remote control.
♦ Insert the batteries, type AAA/Micro into the battery compartment.
Make sure the polarities are correct.
♦ Close the battery compartment.
SWW 1500 A1