Connection Diagram 18 - 24 Kw - EOS Goliath Serie Montage- Und Gebrauchsanweisung

Connection diagram for the sauna heater 18 - 24 kW
Saunasteuergerät
Control unit
Boîtier de commande
5 5
Netz / Mains / Réseau /
Saunasteuergerät / Control unit /
Boîtier de commande /
S1 S1 N L1 L2 L3 N W V U N
400 V 3N AC
Caution! Always make sure to connect the neutral conductor N!
Open the terminal box at the rear side of the sauna heater (loosen the mounting screws and take
off the cover panel).
Draw the connection cables from the control unit and/or power extension unit through the cable
glands into the terminal box of the heater. Make sure to use the wire end sleeves. Connect the N line
to the corresponding terminal of the common N rail and the phase lines to the above positioned
respective phase terminals.
Pay attention to the tightening torque 2.5 - 3 Nm for the terminals. Connect the PE (Ground) line to
the special connection terminal on the housing in the upper area of the terminal box.
After completing the connection mount the cover panel back on the terminal box.
Saunaofen
Sauna heater
Poêle de sauna
4
5
reserviert
Sensorbus
Saunabus
fan light
WB N WM
3 4
L N L N
STB
4
Sensor
Saunaofen
Sauna heater
N U V W
Limiter
EN
Leistungsschaltgerät
Power extension unit
LSG
Extension de puissance
5
LSG 18
LSG
Contactor box
N U V W
U V W N S1 V N
1 1 1 1
L1 L2 L3 N
400 V 3N AC
27