Key Tones; How To Navigate In Setting Mode - JUNO JGVX608D1 Benutzerinformation

AirDry is automatically activated with all
programmes other than Pre Rinse.
CAUTION! Do not try to close
the appliance door within 2
minutes after automatic
opening. This can cause
damage to the appliance.
CAUTION! If children have
access to the appliance, we
advise to deactivate AirDry.
The automatic opening of the
door may pose a danger.

Key tones

The buttons on the control panel make a
click sound when you press them. You
can deactivate this sound.
Latest programme selection
You can set the automatic selection of the
most recently used programme and
options.
The latest programme that was completed
before the appliance deactivation is
saved. It is then selected automatically
after you activate the appliance.
When the latest programme selection is
disabled, the default programme is ECO.
TimeBeam
TimeBeam displays the following
information on the floor below the
appliance door:
• The programme duration when the
programme begins.
• 0:00 and CLEAN when the programme
is completed.
• DELAY and the countdown duration
when the delay start begins.
• An alarm code when the appliance has
a malfunction.
When AirDry opens the door,
TimeBeam is off. To check the
remaining time of the running
programme, look at the control
panel display.
Setting mode
How to enter setting mode
You can enter setting mode before
starting a programme. You cannot enter
setting mode while the programme is
running.
To enter setting mode, press and hold
simultaneously 30min and ECO for about
3 seconds.
• The lights related to 60min, 90min
and Intensive are on.
• The display shows the current
value of the first available setting.

How to navigate in setting mode

You can navigate in setting mode using
programme buttons.
13