Dmx Operation - EuroLite Audience Blinder Bedienungsanleitung

Total brightness
Menu diMM allows adjusting the total brightness for all stand-alone operating modes: STATIC, AUTO and
COLOR.
1 Press the MENU button so many times until diMM is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to adjust the desired brightness (dI 1 = dark, dI 9 = bright). Confirm with
the ENTER button.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit by setting the slaves to the same DMX
address: Press the MENU button so many times until SLAVE is indicated in the display. Confirm with the
ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 6 control channels.
However, it can also be switched to a mode with 2 or 4 channels if different functions are required. To be
able to operate the device with a DMX controller, the DMX starting address must be set for the first DMX
channel. The starting address depends upon which DMX controller is being used. Please refer to the
controller's documentation.
1 Press the MENU button so many times until DMX is indicated in the display. Confirm with the ENTER
button.
2 The display indicates 2CH (2 DMX channels), 4CH (4 DMX channels) or 6CH (6 DMX channels). Use the
buttons UP and DOWN to select the desired number of DMX channels. Confirm with the ENTER button.
3 Now the display indicates the menu item for the DMX start address ADDR:***. Use the buttons UP and
DOWN to set the address. Confirm with the ENTER button.
4 If no control DMX signals are available, the display will flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
2-channel mode
Channel
1
2
Value Function
000 – 255 COB 1, (0-100%)
000 – 255 COB 2, (0-100%)
23/28 00126451, Version 1.0