Charging Instructions - Modster Trainee 1200 Bedienungsanleitung

Manual
6.4 Flying Conditions
Fly the model only on calm days without wind, especially when you have learned to fly. It is also strongly advised to fly only under quiet
conditions, until you are familiar with the controllers and the handling of the model. Already weak winds can make the learning of flying
much more difficult and carry the aircraft away from your field of view.
If you are a beginner, we recommend allowing a more experienced pilot to fly the model and trim properly before attempting your first
flight. A tested, flyable and properly trimmed model is much easier and more comfortable to fly! Please contact your local hobby shop and /
or model flying club to find an experienced pilot in your area.
After properly trimming the aircraft in a quiet environment and being familiar with the handling / characteristics, you can fly in light winds
or experience and self-assessment at wind speeds of up to 8-11 kilometers per hour.
DO NOT fly on days of high humidity such as rain or snow.

6.5 Charging Instructions

To charge the supplied lithium battery, use only the supplied charger (balancer charger and AC adapter) or a compatible lithium charger.
Charging the lithium battery with a charger that is not compatible with lithium batteries (such as a NiCd or NiMH battery charger) or
another lithium battery charger with incorrect settings may damage the battery or even cause property damage or personal injury to lead.
Follow the steps below to charge the lithium battery with the included charger.
1. Connect the supplied balance charger to the AC adapter, then plug the AC adapter into a compatible electrical outlet (varies by country
and area), connect the power cord to the jack on the side of the balance charger, and turn on the balance charger when the green LED is lit.
2. Connect the white 4-pin connector of the battery to the mating connector of the charger.
CAUTION: Make sure the polarity is correct before connecting.
While the white plugs are "scrambled" to minimize the risk of polarity reversal, it is possible to make a wrong polarity connection that may
damage the battery and / or charger. If the ports are properly aligned to ensure correct polarity, the connection should be made only with
moderate pressure to achieve the "click" indicating a secure connection.
3. When the battery is connected securely and in the correct polarity to the charger, both the red and the green LEDs will light up. The
battery is charged as soon as the red LED lights up.
4. It takes approximately 1.5-2.5 hours to fully charge a mostly or fully discharged (not over-discharged) battery. And when the battery is
fully charged, the red LED indicator stops flashing completely. If the red LED indicator turns off, you can disconnect the battery from the
charger as it is fully charged and ready for use.
www.modster.at
MODSTER Trainee 1200
25