Modster Trainee 1200 Bedienungsanleitung Seite 20

Manual
3. Contents
4. Building Instruction
1. Fasten the rudder to the fuselage with the elevator and
tighten the parts with PA2.6 * 8 screws.
3. Attach the push rod (110 mm) to the servo on each side
of the fuselage through the third hole that is counted from
the servo arm edge. Attach the servo arm to the servo with a
PWA2.3 * 4 screw.
20
MODSTER Trainee 1200
2. Mount the control horns of the hinge in the position
provided on the rudder and tailplane, secured by 4 PB2 * 12
screws.
4. Attach the clevis to the hinge control horn through the
second hole that is counted by the horn edge, and tighten
with the rubber band.
www.modster.at