Cold Lamination - Hama KHL38 Original Bedienungsanleitung

g
Press lever
again for any reason.
DANGER
► Laminated items coming out of the device may be too hot to
touch.
NOTE
► The laminated item is hot and easily bent. Place the item on a
flat surface and leave to cool, so that it does not roll up.

Cold lamination

After the device has been switched on, the default setting is 75 μ,
which is shown on operating control
LED is illuminated.
For cold lamination, press button
next to "Cold" flashes.
Place the document to be laminated in the appropriate pouch.
IIf the device has previously been used for hot lamination, it can
take approx. 25 minutes until it has cooled down. The LED next
to "Cold" then stays lit.
Insert the film pouch into the front opening of the device. Make
sure that the sealed end is inserted first.
The document is returned at the rear.
f the item has not been fully laminated, repeat the first steps.
32
Handling and operation
4
downwards if you wish to run the item through
2
as the corresponding
7
repeatedly until the LED
KHL 38