Cold Lamination - Hama HOME L410 Bedienungsanleitung

g

4.3 Cold lamination

After the device is switched on, it is preset to the last temperature
used (see the section on setting the temperature selector (5)).
For cold lamination, set the temperature controller (5) to the setting
"COLD".
Place the document to be laminated in the appropriate pouch.
If the device has previously been used for hot lamination, it can
take approx. 40 minutes until it has cooled down. The ready lamp
(6) lights up continuously in blue.
Insert the lm pouch into the front opening of the device (4). Make
sure that the sealed end is inserted rst.
NOTE
‹ The document is returned at the rear (1).
‹ If an item has not been fully laminated, repeat the rst steps.
‹ Press the roller release button (3) on the back of the device to
run the item through again (if it was pulled in at an angle, etc.).
8
Film pouches of all sizes should be inserted at the centre of
the front opening so that they pass through the sensor.
Home L410