Disposal Of The Packaging; Demands On The Installation Location; Electrical Connection - Hama KHL38 Original Bedienungsanleitung

g

Disposal of the packaging

The packaging protects the unit from transport damage. The pack-
aging materials have been selected according to environmental and
waste disposal aspects and can therefore be recycled.
The return of the packaging to the material cycle helps conserve raw
materials and reduces the production of waste. When no longer re-
quired, dispose of the packaging materials in accordance with the lo-
cal regulations in force.
NOTE
► Keep the original packaging, if possible, during the warranty
period in order to be able to pack the unit properly in the event
of a warranty claim.

Demands on the installation location

For safe and trouble-free operation of the unit, the installation location
has to satisfy the following requirements:
■ Place the unit on a level horizontal surface.
■ Do not install the unit in a hot, wet or very humid environment or in
the vicinity of inflammable materials.
■ Set the unit up in such a way that it is not exposed to direct insola-
tion.
■ The mains socket has to be easily accessible so that the mains
connection can be severed fast, if and when required.

Electrical connection

For safe and trouble-free operation of the unit, the following instruc-
tions have to be observed for the electrical connection:
■ Before connecting the unit, compare the connection data (voltage
and frequency) on the rating plate with those of your mains power
supply. The data have to correspond in order to avoid damage to
the unit.
■ Protect the connecting cable from hot surface and sharp edges.
■ Make sure that the connecting cable is not taut or kinked.
■ Do not permit the connecting cable to hang over edges (trip wire
effect).
28
Setup and connection
KHL 38