Installation And Assembly; Handling And Operation; Switching On The Device - Hama HOME L410 Bedienungsanleitung

3. Installation and Assembly

Remove all packaging materials from the device.
Do not place the device in a hot, wet or very humid environment.
Place the device on a level, horizontal surface so that it is stable.
The socket must be easily accessible so that the power supply can
be disconnected quickly in case of an emergency.
Before you connect the device, compare the connection data for
the device (voltage and frequency) on the type plate with that of
your mains power supply. This data must match to avoid damage
to the device.
Keep the connection cable away from hot surfaces and sharp
edges.
Lay all cables so that they do not pose a tripping hazard.
Do not bend or crush the cable.

4. Handling and Operation

4.1 Instructions for use
Always set the temperature that is correct for the thickness of the
laminating lm being used.
When laminating thick paper or several sheets, it is recommended
to use lm with a low thickness.
Always wait for a lamination process to nish before starting the
next.
Do not run the device for more than two hours at a time and allow
approx. 15 seconds between two laminations.

4.2 Switching on the device

‹ Move the On/Off switch (7) on the right-hand side of the device
to position I.
‹ The power lamp (6) then continuously lights up in red.
Home L410
g
7