Briggs & Stratton 020224 Bedienungsanleitung Seite 12

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
3. ALWAYS point gun in a safe direction and squeeze
spray gun trigger to release retained high water
pressure.
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point gun in safe direction and squeeze spray gun
trigger, to release high pressure, every time you stop engine.
Engage trigger lock when not in use.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
4. Engage safety latch on spray gun when not in use.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun and nozzle extension.There is also a
hook at the front of the accessory tray to hold your high
pressure hose.
NOTE: The extra hole in the tray is for storing a utility
brush.The extra clip in the tray is for storing a turbo
nozzle.The brush and turbo nozzle are NOT included with
your pressure washer.You can buy these items as optional
accessories.
1. Place nozzle extension through hole on accessory tray,
as shown in Figure 15.
Figure 15 — Typical Accessory Tray
WARNING
www.mymowerparts.com
OPERATION
2. Place spray gun through hole on accessory tray on
right side of unit (Figure 15).
NOTE: You may also use the hooks attached to the handle
to store your gun and nozzle extension, as shown on page 6.
3. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown in Figure 15.
How to Use Spray Tips
The quick–connect on the nozzle extension allows you to
switch between four different spray tips.The spray tips vary
the spray pattern as shown (Figure 16).
Figure 16 — Spray Tip Spray Patterns
40° White
Follow these instructions to change spray tips:
1. Engage safety latch on spray gun.
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
• NEVER exchange spray tips without locking the safety latch
on the trigger.
2. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in slots on holder that's
attached to nozzle extension.
12
Low Pressure
Black
Use to apply
detergent
High Pressure
15° Yellow 0° Red
CAUTION