Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Störungen - Harvia WKF300GLB Anleitung

Inhaltsverzeichnis

Werbung

EN
from the stone space, and disintegrated stones
should be replaced with new ones.
Wipe dust and dirt from the stove with a damp
cloth.
Chimney
The chimney and connection pipes should be
swept at regular intervals and especially if the
stove has not been used in a long time.
Due to incomplete burning of fuel and failure
of sweeping the chimney, the soot build-up in
the flue may ignite. Actions to be taken in case
of a chimney fire:
1. Close the ash box, stove door and damper
plate (if installed).
2. Contact local fire authority.
3. Do not try to extinguish fire using water.
4. After a sootfire, a chimney sweeper must check
the stove and the flue before use.

2.8. Troubleshooting

There is no draught in the flue. Smoke comes into
the sauna.
There are leaks in the flue connection. Seal the
connection ( 3.2.4.).
The brick flue is cold.
There is low pressure caused by an extractor
fan or another device in the room. Make sure
there is enough air to compensate.
Several fireplaces are used at the same time.
Make sure there is enough air to compensate.
The ash box is full.
The smoke canals of the stove are blocked
( 2.7.).
The flue connection pipe is too deep in the
chimney ( 3.2.4.).
The sauna does not heat up.
The sauna is too big in relation to the stove's
heating capacity (see table 1).
There is lots of non-insulated wall surface in
the sauna ( 1.).
The burning material is moist or its quality is
otherwise low ( 2.3.).
The flue does not have a good draught.
The smoke canals of the stove are blocked
( 2.7.).
The stove stones do not heat up.
The sauna is too small in relation to the stove's
heating capacity ( 1.).
The flue does not have a good draught.
The burning material is moist or its quality is
otherwise low ( 2.3.).
The smoke canals of the stove are blocked
( 2.7.).
Check the stone placement ( 2.4.). Remove
the small pieces of stone. Replace the
disintegrated stones with large and
undamaged ones.
10
DE
Staub und Gesteinssplitter aus dem unteren Teil
des Saunaofens und ersetzen beschädigte Steine.
Staub und Schmutz vom Ofen mit feuchtem
Tuch abwischen.
Rauchfang
Rauchabzug und Anschlussrohre sind regel-
mässig zu reinigen, insbesondere wenn der
Saunaofen länger nicht benutzt wurde.
Als Folge von unvollständigem Verbrennen des
Holzes und mangelndem Schornsteinkehren
kann sich im Abzug Ruß ansammeln, der in
Brand geraten kann. Im Falle eines Rußbran-
des beachten Sie folgende Anweisungen:
1. Schließen Sie den Aschekasten, die Ofentür
und den Rauchabzug (soweit vorhanden).
2. Kontaktieren Sie die örtliche Feuerwehr.
3. Versuchen Sie nicht, den Rußbrand mit Wasser
zu löschen.
4. Nach einem Rußbrand muss der Schornstein-
feger sowohl die Feuerstelle als auch den
Schornsteinabzug vor dem nächsten Anheizen
kontrollieren.
2.8. Störungen
Im Rauchfang findet kein Luftzug statt. Es tritt
Rauch in die Sauna.
Es gibt undichte Stellen im Anschluss des Rauch-
fangs. Dichten Sie den Anschluss ab ( 3.2.4.).
Der gemauerte Rauchfang ist kalt.
Ein Sauglüfter oder ein anderes Gerät im Raum
führt zu einem Niederdruck. Sorgen Sie im Aus-
gleich für genügend Luft.
Es werden mehrere Feuerstellen gleichzeitig
genutzt. Sorgen Sie im Ausgleich für genügend
Luft.
Der Aschekasten ist voll.
Die Rauchkanäle des Ofens sind verstopft
( 2.7.).
Das Abzugsanschlussrohr darf nicht zu weit in
den Rauchfang hineinreichen ( 3.2.4.).
Die Sauna wird nicht warm.
Die Sauna ist in Relation zur Heizkapazität des
Ofens zu groß (siehe Tabelle 1).
Es gibt viele nicht isolierte Wandoberflächen in
der Sauna ( 1.).
Das Brennmaterial ist feucht oder anderweitig
von schlechter Qualität ( 2.3.).
Der Rauchfang hat keinen guten Luftzug.
Die Rauchkanäle des Ofens sind verstopft
( 2.7.).
Die Saunaofensteine werden nicht warm.
Die Sauna ist in Relation zum Ofen zu groß
oder der Ofen ist zu klein ( 1.).
Der Rauchfang hat keinen guten Luftzug.
Das Brennmaterial ist feucht oder anderweitig
von schlechter Qualität ( 2.3.).
Die Rauchkanäle des Ofens sind verstopft
( 2.7.).
Überprüfen Sie die Anordnung der Steine
( 2.4.). Entfernen Sie die kleinen Steine. Erset-
zen Sie die herausgenommenen Steine durch
große und unbeschädigte.
Der Ofen gibt Gerüche ab.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Wkf300grbWkf300hbWkf300glsWkf300grsWkf300hs

Inhaltsverzeichnis