Installation Instructions - Climadiff DUOVINO/1 Gebrauchsanweisung

4. INSTALLATION INSTRUCTIONS

Before using your temperature control cellar
Remove the inner and outer packaging.
Allow the appliance to rest for two hours before switching it on.
Clean the inside using a soft cloth and lukewarm water.
Using your temperature control cellar:
The appliance must be positioned in a room with an ideal ambient temperature of 25°C.
If the ambient temperature is higher or lower, the appliance's performance may be affected.
Installing your temperature control cellar:
This appliance is designed for free-standing installation.
Position it in a place with sufficient strength to support its weight when loaded. To ensure that it is level,
adjust the height of the feet underneath.
To get the best from your appliance with the lowest energy consumption, do not place the appliance
close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a
room which is too cold.
Connect the appliance to a single socket, leaving a 10 mm gap between the back of it and the wall and 2
cm on each side. Be careful to support it, so that it is perfectly level. (Use of a spirit level is
recommended). This will prevent any movement due to instability, causing noise and vibration, and will
ensure that the door seals perfectly.
Control panel
DUOVINO-1
UPPER ZONE
DOPIOVINO-1
All manuals and user guides at all-guides.com
LOWER ZONE
17