Installation Instructions - Climadiff RESERVE-Serie Gebrauchsanweisung

The name plate attached to the inside or rear of the appliance (depending on the model)
includes all the information specific to your wine cellar.
We recommend that you make a note of its serial number in this booklet prior to installation,
so that you can refer to it later (technical work, request for assistance, etc.)
Once it is installed and loaded, access to it is not so easy.
CAUTION: No assistance can be provided without this information.

4. INSTALLATION INSTRUCTIONS

Before using your wine cellar
•
Remove the inner and outer packaging. Remove your wine cellar from the transport pallet
by unscrewing the two screws on the frame at the back of the device.
•
Before connecting the cellar to the electrical socket, leave it in position for 24 hours. This
will reduce the possibility of malfunction of the refrigeration circuit due to transport.
•
Clean the inside using a soft cloth and lukewarm water.
Ambient room temperature limits
This appliance is designed to operate in ambient temperatures specified by its temperature
class marked on the rating plate.
CLASS
Extended temperate
Temperate
Subtropical
Tropical
This refrigerating appliance is intended to be used at ambient temperatures ranging
from 10 °C to 32 °C
Installing your wine cellar
•
This unit is intended for free-standing installation only. It must never be built-under or
built-in. For proper operation of the appliance, it is imperative to allow good air
circulation around the unit. We do not accept any liability instance of non-compliance with
the installation instructions.
•
Position it in a place with sufficient strength to support its weight when loaded.
•
To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight,
SYMBOL AMBIENT TEMPERATURES RANGE (°C)
SN
N
ST
T
From +10 to +32
From +16 to +32
From +16 to +38
From +16 to +43
51