Eurolite Ir-7 Remote Control - EuroLite ACCU SLS-180 Bedienungsanleitung

EUROLITE IR-7 remote control

Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
Button Function
BLACKOUT All LEDs on/off
AUTO Internal programs
SOUND Sound-controlled mode
MANUAL Manual color selection
0 ~ 9 Static colors
1
The device must be activated for remote control. For this, set menu item SET
to On.
2
When actuating a button, always hold the remote control in the direction of the
sensor. There must be visual connection between the remote control and the
sensor.
3
The remote control is supplied with a battery inserted. An insulating foil
between the battery and the battery contacts prevents the battery from being
discharged during storage. Prior to the first operation remove the foil from the
battery support on the rear side of the remote control. Otherwise operation of
the remote control is not possible.
4
If the range of the remote control decreases (10
meters as a maximum), replace the battery. For this
purpose, on the rear side of the remote control press
the small bar with the groove to the right and at the
same time remove
operation, one 3 V button cell type CR 2025 is required. When inserting, pay
attention that the positive pole of the button cell shows upwards in the support.
not be disposed of with regular domestic waste!
-
Program 1-6 with +/–
Running speed with SPEED and +/–
Fade speed with FADE and +/–
Strobe effect with STROBE and +/–
Microphone sensitivity with SENSITIVITY and +/–
Amber brightness with A and +/-
Red brightness with R and +/-
Green brightness with G and +/-
Blue brightness with B and +/-
0 = white (RGBA), 1 = red, 2 = amber, 3 = yellow, 4 = green, 5 =
cyan, 6 = blue, 7 = magenta, 8 = orange, and 9 = amber
the battery support.
CAUTION!
Setting options
26/30
For
00081934, Version 1.0