Additional Safety Rules; Operation - Panasonic EY503 Betriebsanleitung

Read "Safety Instructions" booklet and the
following before using.
ADDITIONAL
SAFETY RULES
1) Be aware that this tool is always in an
operating condition, since it does not have to
be plugged into an electrical outlet.
2) When drilling into walls, floors, etc., "live"
electrical wires may be encountered. DO NOT
TOUCH THE CHUCK OR ANY FRONT
METAL PARTS OF THE TOOL! Hold the tool
only by the plastic handle to prevent electric
shock in case you drill into a "live" wire.
3) If the bit becomes jammed, immediately turn
the main switch off to prevent an overload
which can damage the battery pack or motor.
Use reverse motion to loosen jammed bits.
4) During charging, the charger may become
slightly warm. This is normal. Do not charge
the battery for a long period.
5) Use only a dry, soft cloth for wiping the unit. Do
not use a damp cloth, thinner, benzine, or
other volatile solvents for cleaning.
6) Wear ear protectors when using the tool for
extended periods.

OPERATION

Hexagonal driving shaft···(A)
NOTE: When attaching or removing bit, be
sure to set the main switch lock at the
lock position.
Select the suitable bit and lightly push it into
the hexagonal driving shaft of the main unit.
(Refer figure 2)
Refer figure 2 for useable bits.
E
Clutch handle···(B)
When using the tool for driving screws into
soft material or for terminal screws, etc., there
is the possibility of damaging the material or
threads if the torque is too high. To
compensate for this, the clutch torque may be
adjsuted by turning the clutch handle to the
required setting.
Clutch position 1 is the minimum and the
clutch torque increases with positions 2, 3, 4,
and 5. When the device is set at position 6,
the clutch will not slip and the connection to
the motor will be direct.
CAUTION: If the battery pack loses its power
during usage, the clutch may not
slip even at positions 4 or 5, if this
occurs, recharge the battery pack.
(Refer figure 3)
Bit locking function
With the switch at off, the bit is locked in place,
and the tool can be used as a manual screw-
driver.
There will be a little play in the driving shaft,
but this is not a malfuncton.
CAUTION: Exact torque should be verified
with a torque wrench for precise
limits as the screw can be
damaged.
(Refer figure 4)
5