Rear Panel Connections - EMPHASER EA450-250 Einbau- Und Bedienungsanleitung

15 REMOTE LOW PASS LEVEL INPUT 5-CH
Telephone jack input socket for connection with the dash-mounted low-pass level remote unit.
The remote low pass level control is for channels 5-CH, and it is only active when the
operation mode switch is set to lowpass!
16 POWER LED
Green "operation" LED, signaling correct operation of the amplifier.
17 PROTECTION LED
Red "protection" LED, signaling faulty speaker connections or general malfunction of the
amplifier.
FRONT PANEL
EA450-250
1CH

2.2 REAR PANEL CONNECTIONS

EA450-250 5-CHANNEL AMPLIFIER
18 SPEAKER OUTPUT TERMINALS 1/2-CH
Output terminal to connect the speakers to the 1/2-CH channels of the amplifier.
19 SPEAKER OUTPUT TERMINALS 3/4-CH
Output terminal to connect the speakers to the 3/4-CH channels of the amplifier.
20 SPEAKER OUTPUT TERMINALS 5-CH
Output terminal to connect the speakers to the 5-CH mono channel of the amplifier.
21 POWER INPUT TERMINAL "GND"
Terminal to connect the amplifier to the negative or ground pole of the car battery.
22 REMOTE INPUT TERMINAL "REM"
Terminal to connect the amplifier to the automatic (remote) turn-on / turn-off lead of the
head unit.
23 POWER INPUT TERMINAL "+12 V"
Terminal to connect the amplifier to the positive +12V pole of the car battery.
2CH 3CH 4CH 5CH
7