Husqvarna 360BT Bedienungsanweisung Seite 64

3. Install the handlebar and the knob. Tighten the
knob.
4. Assemble the intermediate pipe.
To assemble the flat nozzle (optional
accessory)
The flat nozzle gives a higher air speed than the
blower nozzle.
Introduction
WARNING:
the safety chapter before you use the
product.
Fuel
This product has a two-stroke engine.
CAUTION:
result in engine damage. Use a mixture
of gasoline and two-stroke oil.
Premixed fuel
• Use Husqvarna premixed alkylate fuel for
best performance and extension of the engine
life. This fuel contains less harmful chemicals
compared to regular fuel, which decreases
harmful exhaust fumes. The quantity of remains
after combustion is lower with this fuel, which
keeps the components of the engine more clean.
To mix fuel
Gasoline
• Use good quality unleaded gasoline with a
maximum of 10% ethanol contents.
CAUTION:
with an octane grade less than 90
RON/87 AKI. Use of a lower octane
grade can cause engine knocking,
which causes engine damages.
64
Operation
Read and understand
Incorrect type of fuel can
Do not use gasoline
• Remove the blower nozzle from the intermediate
pipe and install the flat nozzle.
Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil.
• If Husqvarna two-stroke oil is not available, use
a two-stroke oil of good quality for air-cooled
engines. Speak to your servicing dealer to select
the correct oil.
CAUTION:
stroke oil for water-cooled outboard
engines, also referred to as outboard
oil. Do not use oil for four-stroke
engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
CAUTION:
influence the ratio of the mixture
drastically when you mix small quantities
of fuel. Measure the quantity of oil
carefully and make sure that you get the
correct mixture.
Do not use two-
Two-stroke
oil, liter
2% (50:1)
0.10
0.20
0.30
0.40
Small errors can
1750 - 003 - 03.03.2022