Installation; Machine Positioning; Water Connection; Water Inlet Hose - IKEA TILLREDA AA-2326089-2 Bedienungsanleitung

2. INSTALLATION

2.1. Machine positioning

When positioning the machine, place
it in an area where dishes can be easily
loaded and unloaded. Do not put the
machine in an area where the ambient
temperature falls below 0°C.
Read all warnings located on the
packaging before removing the
packaging and positioning the machine.
Place the machine close to a water tap
and drain. Take into consideration that
the connections will not be altered once
the machine is in position.
Do not hold the machine by its door or
panel.
Leave an adequate distance around the
machine to allow ease of movement
when cleaning.
Ensure the water inlet and outlet
hoses are not squeezed or trapped
and that the machine does not stand on
the electrical cable while positioning.
Adjust the feet so the machine is level
and balanced. The machine should be
placed on flat ground otherwise it will be
unstable and the door of the machine
will not close properly.

2.2. Water connection

We recommend fitting a filter to your
water inlet supply in order to prevent
damage to your machine due to
contamination (sand, rust, etc.) from
indoor plumbing. This will also help
prevent yellowing and deposit formation
after washing.
Note printing on the water inlet hose!
If models are marked with 25°, the water
temperature may be max. 25 °C (cold
water).
For all other models:
Cold water preferred; hot water max.
temperature 60 °C.

2.3. Water inlet hose

WARNING: Use the new water inlet
hose supplied with your machine, do not
use an old machine's hose.
WARNING: Run water through the
new hose before connecting.
WARNING: Connect the hose
directly to the water inlet tap. The pressure
supplied by the tap should be a minimum
of 0.03 MPa and a maximum of 1 MPa. If
the pressure exceeds 1 MPa, a pressure
relief valve must be fitted between the
connection.
WARNING: After the connections are
made, turn the tap on fully and check
for water leaks. Always turn off the
water inlet tap after a wash program has
finished.
An Aquastop water spout is available
with some models. Do not damage it
or allow it to become kinked or
twisted.
GB - 5