Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Do not fill detergent into the detergent
compartment more than required;
otherwise you can see whitish streaks
or bluish layers on glass and dishes and
may cause glass corrosion. Continued
use of too much detergent may cause
machine damage.
Using little detergent can result in
poor cleaning and you can see whitish
streaksin hard water.
See the detergent manufacturer's
instructions for a further information.
4.9. Filling the detergent
Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in
place. The dispenser should be refilled
just before the start of each programme.
If the dishes are heavily soiled, place
additional detergent in the pre-wash
detergent chamber.
4.10. Using combined detergents
These products should be used according
to the manufacturer's instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the
combination.
We recommend you do not use
combined detergents in short
programmes. Please use powder
detergents in such programmes.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined
detergents, make sure that water
hardness and rinse aid settings are set to
the correct level.
4.11. Rinse-aid usage
The rinse aid helps to dry the dishes
without streaks and stains. Rinse-aid is
required for stain-free utensils and clear
glasses. The rinse aid is automatically
released during the hot rinse phase. If
rinse aid dosage setting set too low,
whitish stains remains on dishes and
dishes do not dry and washed clean.
If rinse aid dosage setting set too height,
you can see bluish layers on glass and
dishes.
4.12. Filling the rinse-aid and setting
To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX
level and then close the cap. Be careful
not to overfill the rinse aid compartment
and wipe up any spills.
In order to change the rinse aid
level, follow the below steps
before turning on the machine:
DETERGENT
•
Open the door of the machine.
•
Turn on the machine, and press the
Programme button as soon as the
machine is turned on.
•
Hold down the Programme button
until "rA" disappears. Rinse aid setting
follows water hardness setting.
•
The machine will display the last
setting.
•
Change the level by pressing the
programme button.
•
Turn off the machine to save the
setting.
The factory setting is "4".
If the dishes are not drying properly or
are spotted, increase the level. If blue
stains form on your dishes, decrease the
level.
GB - 11
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
