Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Water Connection - IKEA RENLIG DWTI60 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für RENLIG DWTI60:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ENGLISH
Noise (dB(A))
Average annual energy
consumption (kWh)
Average annual water con-
2)
sumption (litres)
1) If the pressure in your area is lower or higher, please contact your After Sales Service.
2) The data is based on the washing programme for test institutes assuming 280 cycles per a year.
Information on the electrical connection, voltage and overall power is given on the
rating plate on the inner edge of the dishwasher door.

Installation

Caution! Refer to the assembly
instructions, in order to proceed with
the installation.
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Place the appliance on the floor and install
it under a counter (kitchen worktop or sink).

Water connection

This appliance has a special inlet hose
for water stop later defined as aqua-
lock.
Water inlet hose
Connected the appliance to a hot (max.
60°) or cold water supply.
If the hot water comes from alternative
sources of energy that are more environ-
mentally friendly (e.g. solar or photovoltaic
panels and aeolian), use a hot water supply
to decrease energy consumption.
Connect the inlet hose to a water tap with
an external thread of 3/4".
Caution! Do not use connection hoses
from an old appliance.
Caution! If you connect the appliance
to new pipes or pipes that are not used
for a long time, we recommend to run the
water for some minutes before you connect
the inlet hose.
49
311
2)
4480
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap
and a drain.
For the venting of the dishwasher only wa-
ter fill, water drain and power supply cable
openings are necessary.
Aqualock inlet hose
The inlet hose is a high pressure resistant. It
can hold pressure at maximum 6 MPa. From
external the inlet hose has a sheathing
against eventual damages. If the inner hose
breaks, the water that is in the hose will be-
came dark. You can see it across the special
transparent sheathing. Turn off the water
tap immediately and contact the After Sales
Service.
19

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis