Installation; Water Connection - IKEA RENLIG DW45 Bedienungsanleitung

ENGLISH

Installation

Caution! Refer to the assembly
instructions, in order to proceed with the
installation.
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Place the appliance on the floor and install it
under a counter (kitchen worktop or sink).

Water connection

This appliance has a special inlet hose
for water stop later defined as aqua-
lock.
Water inlet hose
Connected the appliance to a hot (max. 60°)
or cold water supply.
If the hot water comes from alternative sour-
ces of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
aeolian), use a hot water supply to decrease
energy consumption.
Connect the inlet hose to a water tap with an
external thread of 3/4".
Caution! Do not use connection hoses
from an old appliance.
Caution! If you connect the appliance to
new pipes or pipes that are not used for
a long time, we recommend to run the water
for some minutes before you connect the inlet
hose.
Aqualock inlet hose
The inlet hose is a high pressure resistant. It
can hold pressure at maximum 6 MPa. From
external the inlet hose has a sheathing
against eventual damages. If the inner hose
breaks, the water that is in the hose will be-
came dark. You can see it across the special
transparent sheathing. Turn off the water tap
immediately and contact the After Sales
Service.
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap
and a drain.
For the venting of the dishwasher only water
fill, water drain and power supply cable
openings are necessary.
A
B
The aqualock inlet
hose is installed with
a safety device to
prevent accidental
loosening. To dis-
connect the hose:
• Press the lever (B).
• Turn the retaining
ring (A) anticlock-
wise.
19
Turn the inlet hose to
the left or the right
to suit the installa-
tion. Tight the lock-
nut correctly to pre-
vent water leaks.
If you use a in-
let hose exten-
sion the total
reached length must
be no longer than 4
metres.