Installation; Water Connection - IKEA RENLIG DW55 Bedienungsanleitung

ENGLISH
Energy class
Washing class
Drying class
Noise (dB(A))
Average annual energy con-
2)
sumption (kWh)
Average annual water con-
2)
sumption (litres)
1) If the pressure in your area is lower or higher, please contact your After Sales Service.
2) The data is based on the washing programme for test institutes assuming 220 cycles per a year.
Information on the electrical connection, voltage and overall power is given on the rating
plate on the inner edge of the dishwasher door.

Installation

Caution! Refer to the assembly
instructions, in order to proceed with the
installation.
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Install the appliance on a shelf in a furniture of
the kitchen.

Water connection

Inlet hose
The appliance has safety features to prevent
that the water in the appliance goes back into
the drinking water system.
Connected the appliance to a hot (max. 60°)
or cold water supply.
If the hot water comes from alternative sources
of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
aeolian), use a hot water supply to decrease
energy consumption.
It is important that a water tap or stopcock is
near the dishwasher with easy access.
Connect the inlet hose to a water tap with an
external thread of 3/4".
If the water inlet hose is too short, replace the
water inlet hose with an applicable, longer
high-pressure hose. Do not connect an exten-
sion hose.
A
A
B
45
138,6
1540
If a repair is necessary, the appliance must be
easily accessible for the engineer.
Put the appliance adjacent to a water tap and
a drain.
For the venting of the dishwasher only water
fill, water drain and power supply cable open-
ings are necessary.
To suit the installation, it is possible to turn the
end of the hose that is connected to the dish-
washer. Do these steps :
1. Loosen the retaining nut.
2. Turn the hose.
3. Tighten the retaining nut.
before you move the dishwasher into position.
an old appliance.
Drain hose
The appliance has water safety system to pre-
vent water damage. If there is a malfunction,
the drain pump automatically starts to drain
the remaining water out of the dishwasher.
Warning! Make sure that the retaining
nut and all other connections are tight
Warning! Always use a new water inlet
hose. Do not use connection hoses from
18