Preparing The Digitradio 380 Cd Ir For Operation; Aligning The Antenna; Connecting The Mains Cable; Inserting The Batteries Into The Remote Control - TechniSat DIGITRADIO 380 CD IR Bedienungsanleitung

6.3 Preparing the DIGITRADIO 380 CD IR for operation

6.3.1 Aligning the antenna

The number and quality of broadcast stations depends on the reception conditions
at the location of the radio. Excellent reception can be achieved with the telescopic
antenna.
> Release the telescopic antenna (14) from its holder, align it and extend it.
Precise alignment of the antenna is often important, especially on the
outskirts of a DAB+ reception area. You can quickly find the location of the
nearest transmission tower online by visiting "www.dabplus.de".
Start the first scan at a window pointing in the direction of the transmission
mast. If the weather conditions are poor, DAB+ reception may be limited.
Do not touch the antenna during station playback. This could reduce the
reception and lead to sound drop-outs.

6.3.2 Connecting the mains cable

Ensure that the operating voltage matches the local mains voltage before
inserting the mains plug into the wall socket.
WARNING!
Do not touch the mains plug with wet hands; electric shock hazard!
CAUTION!
Route the mains cable in such a way that nobody can trip over it.

6.3.3 Inserting the batteries into the remote control

> Open the battery compartment on the back of the remote control by sliding it
in the direction of the arrow.
> Insert the batteries (2 x AAA 1.5 V) in accordance with the polarity indicated
in the battery compartment.
> Close the battery compartment lid carefully again and ensure that the lid
retaining tabs engage in the housing.
You will need 2 micro alkaline batteries, 1.5 V, LR03/AAA to operate the
remote control. Make sure the polarity is correct when inserting them.
DE
EN
FR
NL
51