TechniSat DIGITRADIO 380 CD IR Bedienungsanleitung Seite 71

If you select [No], the wizard closes and you need to perform the required
settings manually.
You will be taken through the settings in various steps.
> Under [Time format], select the desired display format for the time display
(Section 17.4) and press the OK button.
> During the next step you must select via which source the time and date is to
be synchronised (for more information refer to Section 17.4).
If you have selected [Update from the Net], you must then enter the time
zone and summer time/winter time.
Depending on the time and date settings, some of the network settings are now
performed.
> Select whether the WiFi connection should remain active in standby mode as
well. Press the OK button.
> Ensure that the device is within the reception range of the desired WiFi
network and that you have the access data. In some cases it may be
necessary to carry out some settings on the router. In this case, please refer
to the corresponding instruction manual.
After a search for available wireless networks you are shown the result.
> Select the desired wireless network and confirm the selection with OK. Select
Skip WPS to enter the password.
If it is a protected network you will be asked to enter the corresponding
access key.
> To do this, mark the respective character.
> Enter the selected character by pressing the OK button.
Proceed in this way until the complete access key can be seen in the input
field.
To cancel the input, select
mistake, you can delete the last letter you entered by pressing
> Then select
correct, a connection to the network is now established.
> When [Set-up wizard completed] appears on the display, press the OK
button.
and press the OK button. If you make a
and press the OK button. If the password entered is
DE
EN
FR
NL
.
71