Introduction; Device Description (Fig. 1-12); Scope Of Delivery; Proper Use - Parkside PKO 24 B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

2. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws, the
manufacturer of this device assumes no liability for damage to
the device or caused by the device arising from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised specialists.
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failures of the electrical system in the event of the electrical
regulations and VDE provisions 0100, DIN 57113 / VDE
0113 not being observed.
Please consider:
Read through the complete text in the operating manual before
installing and commissioning the device.
This operating manual should help you familiarise yourself with
your power tool and teach you how to use it for its intended
purpose.
The operating manual includes important instructions for the
safe, proper and economic operation of the machine, for
avoiding danger, for minimising repair costs and downtimes
and for increasing the reliability and extending the service life
of the machine.
In addition to the safety instructions in this operating manual,
you must also observe the regulations applicable to the
operation of the machine in your country.
Keep the operating manual package with the power tool at
all times and store it in a plastic cover to protect it from dirt
and moisture. They must be read and carefully observed by all
operating personnel before starting the work. The power tool
may only be used by personnel who have been trained to use
it and who have been instructed with respect to the associated
hazards. The required minimum age must be observed.
In addition to the safety instructions in this operating manual
and the separate regulations of your country, the generally
recognised technical rules relating to the operation of such
machines must also be observed.
We accept no liability for accidents or damage that occur due
to a failure to observe this manual and the safety instructions.

3. Device description (fig. 1-12)

1. Transport handle
2. Pressure switch
3. Quick coupling (regulated compressed air)
4. Pressure gauge (set pressure can be read off)
5. Pressure regulator
6. Pressure gauge (vessel pressure can be read off)
7. Quick coupling (unregulated compressed air)
8. Pressure vessel
9. Supporting foot
9a. Washer
9b. Screw
10. Drain screw for condensate
11. Wheel
11a. Washer
11b. Fillister head screw
12. Oil drain screw
13. Compressor pump
14. Compressed air hose
14a. Plug nipple
14b. Quick coupling
15. Air filter
15a. Transport lid
15b. Wing screw
15c. Filter element
15d. Filter housing
15e. Filter cover
16. Oil sealing plug
17. On/off switch
18. Oil-level window
19. Safety valve
19a. Exhaust nut
19b. Connection lock
19c. Cap of exhaust nut
20. Oil filling opening
20a. Transport lid

4. Scope of delivery

1x air filter
2x supporting foot
2x wheel
1x assembly material
1x oil sealing plug
1x oil bottle
1x compressed air hose
1x operating manual

5. Proper use

The compressor is designed to generate compressed air for
compressed-air driven tools which can be driven with an air
volume of up to approx. 180 l/min (e. g. tire inflator, blow-out
pistol and paint spray gun). Due to the limited air output it is
not possible to use the compressor to drive tools with very high
air consumption (for example orbital sanders, die grinders and
hammer screwdrivers).
GB 3