DeWalt DW739 Originalanweisungen Seite 26

ENG LI SH
WARNING: To reduce the risk of injury, turn unit off
and disconnect machine from power source before
installing and removing accessories, before adjusting
or changing set-ups or when making repairs. Be sure
the trigger switch is in the OFF position. An accidental start-
up can cause injury.
WARNING: if the saw blade is worn replace it with a new
or re-sharpened blade.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
WARNING: To reduce the risk of injury, regularly clean
the table top.
WARNING: To reduce the risk of injury, regularly clean
the dust collection system.
WARNING: To reduce the risk of personal injury, turn
unit off and disconnect machine from power source before
cleaning. An accidental start-up can cause injury.
Before use, carefully check the adjustable upper and lower blade
blocks, movable door as well as the dust extraction tube to determine
that it will operate properly. Ensure that chips, dust or workpiece particle
cannot lead to blockage of one of the functions.
In case of workpiece fragments jammed between bandsaw blade and
lower blade block disconnect the machine from the power supply and
follow the instructions given in section "Mounting the bandsaw blade".
Remove the jammed parts and reassemble the saw blade.
Keep the motor ventilation slots clear and regularly clean the housing
with a soft cloth.
Dust Extraction
WARNING: Whenever possible, connect a dust extraction
device designed in acordance with relevant regulations
regarding dust emission.
Connect a dust extraction device designed in accordance with relevant
regulation. The air velocity of external connected system shall be 20m/s
+/-2m/s. Velocity to be measured in the connection tube at the point of
connection, with the tool connected but not running.
Transporting
Prior to transporting always disconnect the machine from the power
source. Transport the machine at the carrying points. Always transport
the machine with the guard fully down close to the table. Never carry
the machine by the guard.
Optional Accessories
WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
E
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
24
WALT, recommended
E
Consult your dealer for further information on the appropriate
accessories.
Protecting the Environment
Separate collection. This product must not be disposed of
with normal household waste.
Should you find one day that your D
or if it is of no further use to you, do not dispose of it with household
waste. Make this product available for separate collection.
Separate collection of used products and packaging allows
materials to be recycled and used again. Re-use of recycled
materials helps prevent environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection of electrical
products from the household, at municipal waste sites or by the retailer
when you purchase a new product.
D WALT provides a facility for the collection and recycling of D
E
products once they have reached the end of their working life. To take
advantage of this service please return your product to any authorised
repair agent who will collect them on our behalf.
You can check the location of your nearest authorised repair agent by
contacting your local D WALT office at the address indicated in this
E
manual. Alternatively, a list of authorised D
full details of our after-sales service and contacts are available on the
Internet at: www.2helpU.com.
WALT product needs replacement,
E
WALT
E
WALT repair agents and
E