General Notes On Safety; Use Of The Machine For Purposes For Which It Is Intended; Incorrect Use; Ec Declaration Of Conformity - SUHNER ABRASIVE LWB 21 Originalbetriebsanleitung

1. Notes on Safety

1.1 General notes on safety

This operation manual is applicable for the machine LWB
21.
The machine may only be handled by personnel
who are qualified.
1.2 Use of the machine for purposes for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with milling cutters and grinding
attachments.

1.3 Incorrect use

All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.

1.4 EC declaration of conformity

Translations of the «EG-Koformitätserklärung (Original)».
Suhner Schweiz AG, Industriestrasse 10, CH-5242 Lup-
fig, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side)
complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: T. Fischer. CH-Lupfig, 11/2019.
T. Fischer/Managing Division manager
2. Commissioning

2.1 Prior to taking the machine into service

Use oiled compressed air (see also air
quality under section 2.3). Observe nation-
al regulations.

2.2 Taking the machine into service

Before connecting the tool to the com-
pressed air supply set the sleeve to the
«OFF» position! The tool may be switched
on only when the attachment have been installed correct-
ly.
18
2.2.1 Turn on/Turn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
Alternative
Switch on the tool by turning in the direction of the arrow
to the stop. Turn back to switch off the tool.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.

2.3 Rating data

Pressure
Power output
Air consumption full load EN ISO 15744
Air consumption at idling EN ISO 15744
Setting oiler idle
No-load speed
Sound pressure level EN ISO 15744 74dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight

2.4 Operating conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
max. 6.3bar
250W
0.52m /min
3
0.6m /min
3
about 2-3 drops/min
25000min
-1
3.6m/s , K=2.3m/s
2 2
3/4/4
0.380kg