1. Notes on Safety
1.1 General notes on safety
This operation manual is applicable for the machine LWE
10-TOP.
The machine may only be handled by personnel
who are qualified.
1.2 Use of the machine for purposes for
which it is intended
The machines are intended for the purpose of cutting,
roughing and brushing of metal and stone materials.
1.3 Incorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 EC declaration of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 10/2019.
T. Fischer/Managing Division manager
2. Commissioning
2.1 Prior to taking the machine into service
Si raccomanda aria compressa oleosa(see
also air quality under section 2.3). Ob-
serve national regulations.
2.1.1 Fitting of hose coupling
Fitting of hose coupling inside diameter min. 7mm (avail-
able as optional accessory, item no. 90805700).
20
2.2 Taking the machine into service
2.2.1 Turn on/Turn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
2.3 Rating data
Pressure
Power output
Air consumption full load EN ISO 15744
Air consumption at idling EN ISO 15744
Setting oiler idle
No-load speed
Max. wheel diameter
Grinding spindle thread
Sound pressure level EN ISO 15744 79dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
2.4 Operating conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. handling / Operation
3.1 Protective devices
The machine may only be operated with
the safety guards and the additional han-
dle fitted!
max. 6.3bar
600W
1.05m
/min
3
1.3m
/min
3
about 5-6 drops/min
10000min
-1
115mm
M14 / 5/8"
4.9m/s
, K=1.6m/s
2
2
3/4/4
1.600kg