Help In Case Of Malfunction; Transport - AL-KO CSA 4020 Betriebsanleitung

GB
NOTE A worn or damaged drive sprocket
reduces the service life of the saw chain, and so
the drive sprocket should be renewed without de-
lay by the customer service.

8 HELP IN CASE OF MALFUNCTION

CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work!
Malfunction Cause
The guide rail The saw
and saw chain is ten-
chain become sioned too
hot when run- tightly.
ning. Genera-
Oil tank is
tion of smoke.
empty.
The oil entry
hole and/or
groove of
the guide rail
are dirty.
Motor run- The saw
ning, but the chain is ten-
saw chain sioned too
does not tightly.
move.
Appliance
faults
Only sawdust The saw
is thrown out, chain is
rather than blunt.
wood chips.
The pole-
mounted
pruner must
be forced
through the
wood.
Appliance vi- Appliance
brates unusu- faults
ally.
Other faults See "Multitool MT 40 – basic
appliance" operating instruc-
tions.
34
Remedy
Check the chain
tension. Re-ten-
sion the saw
chain.
Replenish the
saw chain oil.
Clean the oil en-
try hole and
groove of the
guide rail.
Check the chain
tension. Re-ten-
sion the saw
chain.
Contact an AL-
KO service cen-
tre.
Sharpen the
saw chain or
contact an AL-
KO service cen-
tre.
Contact an AL-
KO service cen-
tre.
NOTE If you encounter any malfunctions
that are not listed in this table or that you cannot
rectify yourself, please contact our customer ser-
vice.

9 TRANSPORT

Before transporting, carry out the following mea-
sures:
1. Switch off the tool.
2. Remove the rechargeable battery from the
basic appliance.
3. Separate the basic appliance, extension pipe
(if present) and attachment from each other.
NOTE The nominal energy of the re-
chargeable battery is more than 100 Wh. There-
fore, observe the following transport instructions.
The li-ion rechargeable battery contained in the
appliance is subject to the hazardous goods law,
but can be transported under simplified condi-
tions:
■
The rechargeable battery can be transported
on public roads by the private user without
further conditions provided it is packaged for
retail sale and the transport serves personal
purposes.
■
Commercial users who carry out the trans-
port in connection with their main activity
(e.g. delivery from and to building sites, or
demonstrations) can also take advantage of
this simplification.
In both cases, it is essential to take the mandato-
ry precautions mentioned above to prevent any
leakage of the contents. In other cases, it is es-
sential to comply with the regulations of the haz-
ardous goods law. In the case of non-compli-
ance, severe penalties can be imposed on the
sender and possibly the transporter.
Additional notes on transport and shipment
■
Only transport or send the li-ion rechargeable
battery in an undamaged condition.
■
For transporting the rechargeable battery, on-
ly use the original cardboard box or a suitable
hazardous goods cardboard box (not re-
quired for rechargeable batteries with a nomi-
nal energy less than 100 Wh).
■
Tape off exposed rechargeable battery con-
tacts to avoid a short circuit.
■
Secure the rechargeable battery against
shifting in the packaging to avoid damage to
the rechargeable battery.
Help in case of malfunction
CSA 4020