Maintenance Guide - Citysports CS-WP3 Bedienungsanleitung

ＥＮ

8. Maintenance Guide

Warning
Always unplug the walker before maintaining the appliance.
Use a cloth to clean the surface of the appliance.

Full cleaning will extend the life of the machine.

Regularly remove dust to keep parts clean, sweeping both sides of the running belt and exposing

the exposed parts, which will reduce the accumulation of impurities in the running belt. Keep your
sneakers clean and avoid carrying foreign objects under the running belt, wearing the running
board and running belt. The surface of the running belt should be scrubbed with a damp cloth
coat coat edgy with soap, be careful not to spill water on the electrical components and under
the running belt.
Check and lock all parts of the treadmill frequently, replace those defective parts and/or leave

the equipment idle for repair.
1、Adjusting The Running Belt
If you appear to be running with slips or is not smooth when using a walking machine, you can
adjust the tightness of the running belt to improve.
Adjusting running has two functions: loose adjustment and center of the running belt. The
running belt is already adjusted at the factory, but after use, the running belt will be stretched
and will deviate from the center of the running band to rub the foot edge and the rear cover
and damage. It is normal for the running belt to be stretched during use.
Adjusting The Running Belt Method
Step 1: Insert the 5mm hex wrench into the adjustment screw on the left side of the running belt
and rotate the wrench clockwise 1/4 turn to adjust the rear roller to tighten the running belt.
Step 2: Insert the 5mm hex wrench into the adjustment screw on the right side of the running belt
and rotate the wrench clockwise 1/4 turn to adjust the rear roller to tighten the running belt.
Step 3: Repeat steps one and two until the running belt does not slip.
Note that the running belt cannot be adjusted too tightly. This will pull the running belt, increase
the pressure of the front / rear drum, the drum bearings, etc. bring damage, produce a different
sound or other problems.
If you want to reduce the tension of the running belt, rotate the wrench counterclockwise, noting
that the left and right sides rotate the same distance.
The running belt is adjusted to the center
Https://www.LikeSporting.com
tight
loose
- 9 -
tight
loose