M. J. MAILLIS GROUP SIAT S2-S A Bedienungsanleitung Und Ersatzteile Seite 88

12-OPERATION
12.6 TABLE OF ADJUSTMENTS
OPERATIONS
Tape loading
Tape alignment
Checkout of the safety devices
Adjustment of tape drum friction brake
Box size adjustment
Adjustment of flap compression rollers
Adjustment of tape applying spring
Conveyor bed height adjustment
Special adjustment: Tape leg
Special adjustment: Column extension
12.7 SAFETY DEVICES CHECKOUT
1 Taping units blade guard (section 10.1)
2 Lockable emergency stop button (section 10.1)
3 STOP (OFF) button on main switch (sections 7.9.3 and 9.1)
12.8 TROUBLE SHOOTING
TROUBLE
When pressing the ON button, the
machine does not start.
The magnetothermic protection
opens the main switch.
The motor runs but the side drive
belts stop.
Drive belts turn but do not convey the
box.
ENGLISH
OPERATOR'S SKILL
1
1
1
1
1
1
1
1
2
2
CAUSE
The lockable emergency stop button
is pressed.
Short circuit in the electrical system.
Motor under stress .
Thermal cut-out not at correct amperage setting.
Belts tension too low.
Worn out drive pulleys.
Worn out belts
Flap compression rollers are too
close inward.
88
SECTIONS
11.1 - 11.2
11.3
12.8
11.4
11.6
11.8
11.5
7.4
11.9
11.10
SOLUTION
Release the emergency stop button by
turning it anticlockwise.
Check the electrical system.
Check that the drive belts are not blocked
Set the correct amperage.
Adjust belt tension.
Check the wear of the rings and replace
them when necessary.
Replace drive belts.
Reposition.
January 2007