Endress+Hauser Promag 400 Index C Installationsanleitung Seite 16

EA01098D
9.3 Reassembling the transmitter housing, remote version
Reassembly is carried out in reverse order.
Make sure that the plug of the ISEM (graphic 1 below) is plugged in correctly.
1
For detailed information on the electrical connection, see the "Electrical connection"
section of the Operating Instructions for the device.
For detailed information on commissioning, see the "Commissioning" section of the
Operating Instructions for the device.
9.4 Canceling the error message after restarting the measuring
device
After the measuring device has been restarted, an error message triggered by the empty
S-DAT appears on the display.
1
1. → "Maintenance" or "Service" login level
2. → Restore S-DAT backup
3. → confirm with "OK"
16 Endress+Hauser