Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
UH 650 hammer drill
It is essential that the operating instructions
are read before the tool is operated for the
first time.
Always keep these operating instructions
together with the tool.
Ensure that the operating instructions are
with the tool when it is given to other
persons.
Operating controls and parts
Chuck (quick-release chuck or key-type
chuck with key)
Side handle with depth gauge
Function selector switch
2-speed gear selector switch
Forwards/reverse switch
On/off switch with electronic speed control
Lockbutton for sustained operation
Supply cord
Contents
1. General information
Printed: 07.07.2013 | Doc-Nr: PUB / 5071286 / 000 / 00
1. General information
1.1 Safety notices and their meaning
-CAUTION-
Draws attention to a potentially dangerous situation that
could lead to minor personal injury or damage to the
equipment or other property.
-NOTE-
Draws attention to instructions and other useful infor-
mation.
1.2 Pictograms
Warning signs
General
warning
Obligation signs
Wear a
Wear eye
hard hat
protection
Symbols
Read the
operating
instructions
before use
These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cover
pages. Keep these pages open while studying the oper-
ating instructions.
Page
In these operating instructions, the UH 650 is referred
11
to as " the tool ".
12
Location of identification data on the tool
13
The type designation can be found on the rating plate
13
and the serial number on the side of the motor housing.
14
Make a note of this data in your operating instructions
16
and always refer to it when making an enquiry to your
16
Hilti representative or service department.
18
19
Type:
19
20
20
Serial No.:
Warning:
electricity
hot surface
Wear
Wear ear
breathing
protection
protection
Return waste material
for recycling
en
Warning:
Wear
protective
gloves
11
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
