Herunterladen Inhalt Inhalt Diese Seite drucken

Vitek VT-1452 ST Die Betriebsanweisung Seite 4

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 7
ENGLISH
cord or the power plug during operation of
the unit.
Do not allow children under 8 years of age to
use the unit as a toy.
Close supervision is necessary when chil-
dren under 8 years of age or disabled per-
sons are near the operating unit.
This unit is not intended for usage by chil-
dren under 8 years of age.
Children aged 8 and over as well as disabled
persons can use this unit only under supervi-
sion of a person who is responsible for their
safety if they are given all the necessary and
understandable instructions concerning the
safe usage of the unit and information about
danger that can be caused by its improper
usage.
To avoid risk of electric shock or fire, do
not immerse the unit, the power cord and
the power plug of the unit into water or
any other liquids. If the unit is dropped into
water:
do not touch the water;
unplug the unit immediately, only after that
you may take the unit out of water;
apply to an authorized service center for
testing or repairing the unit.
To avoid damages, transport the unit in orig-
inal package only.
Keep the unit in a dry cool place out of reach
of children and disabled persons.
Do not repair the unit by yourself. Do not
disassemble the unit by yourself, if any mal-
function is detected or after it was dropped,
unplug the unit and apply to any authorized
service center from the contact address list
given in the warranty book and on the web-
site www.vitek.ru.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
BEFORE USING THE UNIT
After unit transportation or storage under
cold (winter) conditions, it is necessary to
keep it for at least two hours at room tem-
perature before switching on.
Wash the attachments that will contact
products with warm water and a neutral
detergent and dry them thoroughly before
use.
VT-1452.indd 4
Wipe the motor unit (3), the geared lid (9)
and the whisk gear (12) with a soft slightly
damp cloth and then wipe them dry.
Attention!
Do not immerse the motor unit (3), the
whisk gear (12), the geared lid (9), the
power cord and the power plug into
water or any other liquids.
Do not put the attachments and bowls in
a dishwashing machine.
Continuous operation time
Continuous operation time while working
with the blender attachment and the whisk
should not exceed 1 minute, continuous
operation time with the chopper should not
exceed 20-30 seconds.
Make at least a 2-3 minute break between
operation cycles.
USING THE BLENDER ATTACHMENT
WARNING: Before assembling and install-
ing attachments, make sure that the
power plug is not inserted into the mains
socket.
Attach the blender attachment (1) to the
motor unit (3), a click of the locks (2) shows
that the attachment is set properly.
Insert the power plug into the socket; the
button (5) illumination will light up.
Immerse the blender attachment (1) into the
bowl with products that you want to chop/
mix; you can use the measuring cup (10)
for it.
To switch the unit on, press and hold down
the button (5). Set the required rotation
speed of the blender attachment (1) using
the control knob (6). Use this operation
mode for mixing liquid products.
If you press and hold down the turbo mode
button (4), the unit will operate at maximum
rotation speed. Use this operation mode
for combined processing of liquid and hard
products.
Notes
Products should be put into the bowl before
the unit is switched on.
The amount of processed products should
not exceed 2/3 of the capacity of the bowl in
which they are processed.
Before you start chopping/mixing, we rec-
ommend to peel fruit, remove inedible
4
14.09.2015 11:24:59

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis