Race Mode - Athena GET LC-GPA Bedienungsanleitung

The central red LC LED will be steady indicating the activation of "Launch Control" mode.
NOTE: It is possible to activate the "Launch Control mode" only with engine running
below 8000 RPM and with throttle position below 10%.
The "Launch Control" mode enables:
- A visual assistance for the rider: in this mode the LEDs turn on in sequence as
the engine RPM increases. Once all have turned on fixed (all the 10 blue and 2 red),
this informs the rider of the correct RPM level to maintain to ensure a good start.
If this threshold (i.e., 1500 RPM below the limiter) is exceeded, all the LEDs will
flash, informing the rider to close the throttle slightly to return to the optimal value.
NOTE: The RPM threshold can be edited using GET Maya Advanced programming
software (sold separately).
- A specific strategy on the power map to let the engine release the power at its
best during the start. 20 levels of LC assistance can be selected and set on the map
(0=NO assistance, 20=MAX assistance).
NOTE: Select the level that fits you more (e.g., according to the type of soil) using GET
WiFiCOM with WiGET App or GET Maya Advanced programming software (sold separately).
Just after the start all LEDs will turn off except for the central LC LED. As soon
as the rider closes the throttle getting into the corner, Launch Control Mode will
automatically turn off, switching to the GPA Display mode.
While on "Launch Control mode" it is possible to switch manually to "GPA display
mode" holding the mode button pressed for 2,5 seconds.
EN
10
HI-TEMP ALARM
Hi-Temp alarm
When the engine temperature exceeds 100°C (212°F) MFL
LED will start flashing to let the rider be aware of the potential
danger. As the temperature goes below 95°C (203°F) the MFL
LED will turn off.
LC
NOTE: The temperature thresholds can be edited using GET
Maya Advanced programming software (sold separately).
MFL

RACE MODE

Race Mode allows to disable Shift Light and Hi-Temp Alarm.
This would allow some riders to stay more focused during the race, using the help of
the flashing LEDs only on training. "Race Mode" can be enabled using GET WiFiCOM
with WiGET App or GET Maya Advanced programming software (sold separately).
It is possible to set LEDs brightness as well.
GET MAYA ADVANCED: THRESHOLD VALUES MANAGEMENT
Find the data and related values that can be edited with GET programming
software in the chart at the end of this manual.
E. SYMBOLS AND CERTIFICATIONS
We declare that this product supplied is compliant with RoHS Directive
2011/65/EU amended by the Directive 2015/863/EU (RoHS3) relative
on the Restriction of the Use of Certain Hazardous Substances.
11
EN