10.
HP 1900 S / HP 2300 S
1.
2. Open the gasoline tap
3. Move the gas lever to starting position.
4.
starter cable
5.
plate starts to work
6.
7. Move gas lever to working position
8.
1.
2. Move the gas lever to the starting position
3. Set the start switch to "on"
4.
5.
6. Move the gas lever to the working position
7. Plate compactor will begin to function
1. Set the gas lever to slow.
2. Switch machine to OFF.
• Before putting the machine into operation it is im-
tions.
• Observe the national regulations for working when
•
dangerous area.
• Search the working area for foreign bodies and
remove them.
•
down the motor.
11.
shut down the motor.
HP 1900 S / HP 2300 S
ing hours.
1 For tensioning the vee-belt, the bolts A of the
24 | GB
2 Now release the two counternuts B and tension
the vee-belt with both bolts C.
3
bolts A and the counternuts B. Fig. 4.1
HP 1400 S
After 5 hours in use, the fan belt must be tightened.
1 To tighten the fan belt, the screws A on both sides
of the motor housing must be loosened.
2 Now tighten the fan belt with the nut C.
3 After tightening of the fan belt 4, tighten the
screws A again. Fig. 4.4
1
a suitable bin.
2
oil drain.
3
4 Fill the oil in, check with the measuring stick, and
close.
5
ulations.
It is not allowed to drain waste oil onto the ground or
mix it with other waste material.
-
To remove the oil proceed as follows:
1
a suitable bin.
2
oil drain.
3
1.
unit has cooled.
2.
3.
-
unit housing.
4. Lift the entire upper part of the plate vibrator with
the engine off the eccentric vibration unit housing
Fig.
www.scheppach.com
-
-