Scheppach 5904615903 Original Bedienungsanleitung Seite 23

HP1400S HP1900S HP2300S
Sound pressure
level L
Sound power
level L
vibration a 2
h
2
The values stated are emission values and are there-
there is a correlation between emission and immis-
the effects, the characteristics of the work room, oth-
er sources of noise etc., for example, the number of
the user to make a better estimation of dangers and
risks.
8.
Additional parts that are to be attached to the ma-
oil monitor that protects the engine from damage if
the oil level is too low.
If the oil level is too low, the engine switches itself
off; in this case, proceed as described in the mainte-
81,5
82
101,5
102
2,40
2,2
2 2
2 2
-
-
www.scheppach.com
9.
Fixing parts:
2 hexagon bolts M 10 x 65
2 washers 10 mm dia.
2 lock nuts
1 hexagon bolt M 5 x 25
secure with 2 hexagon bolts M 10 x 65, 2 washers 10
mm, and 2 lock nuts. Fasten the gas lever with slot-
ted screw M 5 x 25 to the upper handle. Fig. 2.2
Fixing parts:
2 hexagon bolts M 10 x 30
2 washers 10 mm dia.
2 lock nuts M 10
Fasten the pre-assembled wheel base to the holding
brackets using 2 hexagon bolts M 10 x 30, 2 washers
10 mm, and 2 lock nuts
folded up and latched into the hooks on the lower
handle frame.
For transport purposes, the upper handle frame
hooks on the lower handle frame and swung under
be moved.
Fixing parts:
3 hexagon bolts M 10 x 30
3 spring washers A 10 mm dia.
For mounting the rubber mat, the machine with the
rubber plate has to be placed onto the rubber mat.
ing bar, 3 hexagon bolts M 10 x 30 and 3 washers 10
Attention:
stones, concrete plates and similar materials. For vi-
brating gravel, stone chips and similar materials, the
rubber mat must be removed.
-
GB | 23