Vibration And Noise Reduction - Parkside PWSAP 20-Li C3 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Additional safety instructions for wire
brushing operations – Safety warnings
specific for wire brushing operations
1) Be aware that wire bristles are
thrown by the brush even during
ordinary operation. Do not
overstress the wires by applying
excessive load to the brush. The wire
bristles can easily penetrate light clothing
and/or skin.
2) If the use of a guard is recommended
for wire brushing, do not allow any
interference of the wire wheel or
brush with the guard. Wire wheel or
brush may expand in diameter due to work
load and centrifugal forces.
Additional angle grinder warnings
1) Only use grinding wheels where the indicated
rotational speed is at least as high as what
has been specified on the name plate of the
product.
2) Carry out a visual inspection of the cutting or
grinding wheel before use. Do not use any
damaged or deformed wheels. Replace any
damaged or worn wheels.
3) Make sure that the sparks produced by
grinding do not present a danger, e.g. reach
people or ignite flammable substances.
4) Always wear safety goggles, safety gloves,
respiratory protection and ear protection
when grinding.
5) Never keep the fingers between the wheel
and spark protection or in close proximity
to the protective hoods. There is a risk of
crushing.
6) The rotating parts of the product cannot be
covered due to functional reasons. Therefore,
proceed cautiously and hold the workpiece
firmly in order to avoid slipping which could
cause your hands to come into contact with
the cutting or grinding wheel.
7) The workpiece gets hot during grinding. Do
not touch the machined area, allow it to cool
down. There is a risk of burning. Do not use
coolants or the like.
8) Do not work with the product, if you are tired
or have consumed alcohol or tablets. Always
have a break on time.
9) Turn off the product and, before doing any
servicing, remove the battery pack.
˜ Vibration and noise reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low-noise operating modes as well
as wear personal protective equipment.
Take the following points into account to minimise
the vibration and noise exposure risks:
Only use the product as intended by its
design and these instructions.
Ensure that the product is in good condition
and well maintained.
Use correct accessory tools for the product
and ensure they are in good condition.
GB/IE 47